BISON SILICONE WHITE CARD

BISON SILICONE WHITE CARD

3.50

Bison Silicone White Card. Universal silicone  sealant.

SKU: 8710439101125 Category:

Description

PROPERTIES

  • (Sea)water resistant
  • Permanently elastic
  • UV and all-weather resistant
  • Mould resistant
  • Excellent bonding on all surfaces
  • Chemical resistant
  • Colourfast
  • Easy to apply
  • Resistant to temperatures between -50°C and +120°C

SUITABLE FOR:

Suitable for sealing joints, seams and cracks in all kinds of applications. Suitable for sealings in sanitary and construction applications, for example in the house, glass construction, display case construction, car, boat and caravan. Also suitable for bonding and sealing clear glass, display cases and display windows. Adheres to almost all materials. Not suitable for bitumen, polyethylene, polypropylene, PTFE and aquariums.

NOT SUITABLE FOR:

Not suitable for polyethylene (PE), polypropylene (PP), PTFE and bitumen.

BEFORE USE:

Working conditions

Only apply at temperatures between +5°C and +40°C.

Surface requirements

The surface should be dry, clean and free of dust and grease. Synthetics should first be roughened and/or pre-treated with BISON Silicone Primer.

Preliminary surface treatment

For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.

Tools

Apply cartridge with a Power Pistol. Multi Tool to open the cartridge and tooling the sealant.

Coverage

Content suitable for approx. 8 to 15 m (depending on the diameter of the joint).

DURING USE:

Handling of packaging

Use sealant gun to handle cartridge. Open the cartridge by cutting off the plastic nipple on the top side at the screw thread with a sharp knife. Screw on the nozzle and chamfer at the desired width.

Directions for use

Ensure a minimum joint width of 6 mm and a maximum of 20 mm. The joint depth depends on the joint width. Keep a joint depth of 6 mm up to a joint width of 12 mm. Beyond that, the joint depth should be half the joint width. Inject the sealant evenly into the joint and tool within 10 minutes with a putty knife, moistened with a soap solution. Remove the applied masking tape immediately after tooling. After approx. 10 minutes, a surface skin will form.

Points of attention

Silicone hardens under the influence of humidity. Contact with humidity is therefore absolutely necessary during curing. Alijd consider a joint of at least 6 mm wide.

AFTER USE:

Stains/residue

Immediately remove stains with white spirit. Cured sealant can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +5°C and +25°C.

Additional information

Brand

Bison

Type

Silicone White Card

Go to Top